Skip to content

XH-M03: A model file is cut short

The server read a model file (.mdl) that is shorter than its own header says.

xHLDS version
3.15.0-hs.15
Updated

Printed: when the server reads the model file (a precache or a map load), xhlds_model_check 1, and the file is then loaded as before; with xhlds_model_check 2 the server stops with this line as a FATAL ERROR, as for a missing model.

The server read a model file (.mdl) that is shorter than its own header says: its model loader reads past the end of such a file. Usually an upload or copy that stopped part way. The line names the file, its size and the size its header gives ("damaged" instead: the header asks for a copy of a negative size).

The server then loads the file as before, as ReHLDS does. Reading past the file can crash the server, often only on some map loads; when it does, this line has named the file.

Is it a problem? Yes: the server can crash on any map that uses the model.

What to do: upload the file again in full (its size must match the original's), or take it out of the plugin config or map that uses it.

xhlds_model_check 2 stops the server instead (FATAL ERROR, as for a missing model, and a crash report whose sys_error= has this line), for test servers where it must not be missed; hlds_run or the panel then starts it again into the same error. xhlds_model_check 0 turns the check off. Protected models whose header looks wrong but whose reads stay inside the file are not reported.

On the server

xhlds_explain XH-M03 prints this explanation on the server console, also over rcon.

Licences, prices and what xHLDS adds: xHLDS licence and prices.

Something wrong or unclear on this page? Email office@hostsrc.com or tell us on Discord (external site, opens in a new tab).